Rib of beef
2 sticks of celery
2 sticks of rosemary picked and finely chopped
Season the joint with salt, then peel and roughly chop the veg and place in the bottom of the roasting tray to act as a trivet. Drizzle some good quality olive oil over the joint, sprinkle the chopped rosemary over the meat and place in a preheated oven at 230C – 250C.
Baste the joint frequently with the juices and fat that run out of the meat. Reduce the heat to 200C once the meat has sealed. The total roasting time is 15 minutes per 500g plus 15 minutes, or until the juices run clear.
Once removed from the oven the joint should be rested for 15 minutes before carving.
While the meat is resting, remove the fat and oil from the roasting tray, this is best done by lifting one corner of the tray carefully so the liquid runs to the opposite corner, then simply spoon off the clear liquid. Next get the roasting tray over a high heat and use a wooden spoon to gently work any bits that are stuck to the tray loose, at this point it’s a good idea to add a generous measure of red wine or (my personal preference) port to help “de-glaze” the tray.
Once all the pieces have been worked loose, think about how much gravy you want when finished and add roughly twice that amount of hot beef stock to the roasting tray, bring it to the boil and remove from the heat.
Now strain this through a sieve into a clean saucepan and bring to a boil. Allow the liquid to reduce by half and it should thicken just enough to give a really rich gravy, if it thickens too much just stir in a little stock to thin it down again.